Methanol Synthesis with Steel Mill Gases: Performance Investigations in an On-Site Technical Center

An on-site laboratory with direct access to cleaned and conditioned steel mill gases was recently put into operation. The long-term performance and stability of Clariant's MegaMax®800 methanol synthesis catalyst utilizing steel mill gases is currently being investigated. First test results revealed that in order to investigate deactivation mechanisms arising from particular properties of the cleaned steel mill gases, the overlaying effect of thermal deactivation of the catalyst has to be minimized.     

Effect of suspension characteristics on the performance of thermal barrier coatings deposited by suspension plasma spray

This paper investigates the influence of suspension characteristics on microstructure and performance of suspensions plasma sprayed (SPS) thermal barrier coatings (TBCs). Five suspensions were produced using various suspension characteristics, namely, type of solvent and solid load content, and the resultant suspensions were utilized to deposit five different TBCs under identical processing conditions. The produced TBCs were evaluated for their performance i.e. thermal conductivity, thermal cyclic fatigue (TCF) and thermal shock (TS) lifetime. This experimental study revealed that the differences in the microstructure of SPS TBCs produced using varied suspensions resulted in a wide-ranging overall TBC performance. All TBCs exhibited thermal conductivity lower than 1 W/(m. K) except water-ethanol mixed suspension produced TBC. The TS lifetime was also affected to a large extent where 10 wt % solid loaded ethanol and 25 wt % solid loaded water suspensions produced TBCs exhibited the highest and the lowest lifetime, respectively. On the contrary, TCF lifetime was not as significantly affected as thermal conductivity and TS lifetime, and all ethanol suspensions showed marginally better TCF lifetime than water and ethanol-water mixed suspensions deposited TBCs.     

FPGA互连测试中的反馈桥接故障覆盖问题

现场可编程门阵列(FPGA)内部资源众多,其中互连资源出现故障的概率远远高于片内其他资源,而在以往许多互连测试研究中,所生成的测试配置存在无法覆盖反馈桥接故障的难题,所以较难有测试配置实现故障列表的100%覆盖。因此通过约束桥接故障只发生在单个查找表(LUT)内的信号线上,并结合单项函数,对反馈桥接故障模型进行优化改进,从根本上解决难题；然后对优化后的反馈桥接故障设置相应的约束条件,再使用布尔可满足性理论(SAT)生成满足约束条件的测试配置。采用优化后的故障模型对ISCAS"89基准电路进行了测试配置生成实验,结果表明生成的测试向量解决了反馈桥接故障的覆盖难题,并且在实现故障列表的100%覆盖下,优化后的故障模型所需要的测试配置数最少。     

基于SVD和SSA-VMD降噪的轴承故障特征提取

针对强噪声背景下轴承故障特征提取困难的问题，提出一种基于奇异值分解和参数优化变分模态分解联合降噪的轴承故障特征提取方法(SSVMD)：首先，对原始信号进行奇异值分解(Singular Value Decomposition，SVD)处理，运用奇异值差分谱法选取有效奇异值并将原始信号重构得到初步降噪信号；其次，为防止故障信息丢失，将残余信号进行麻雀算法(Sparrow Search Algorithm，SSA)优化的变分模态分解(Variational Mode Decomposition，VMD）算法处理，得到最佳的模态个数K和惩罚参数α，选取峭度值最大、包络熵最小的IMF分量与初步降噪信号叠加得到最终降噪信号，并对信号进行包络分析；最后，通过仿真和试验数据分析得出，该方法能在信噪比很低的情况下降低噪声含量并提取轴承故障特征，为设备的状态监测和故障诊断提供理论依据。     

浅议生态环境监测机构的风险控制

现阶段,为了探索创新性的发展途径,生态环境监测机构应始终增强风险控制意识。应加强风险管理,立足于风险控制,以求不断健康发展。     

Update on the Diagnostic Pitfalls of Autopsy and Post-Mortem Genetic Testing in Cardiomyopathies

Inherited cardiomyopathies are frequent causes of sudden cardiac death (SCD), especially in young patients. Despite at the autopsy they usually have distinctive microscopic and/or macroscopic diagnostic features, their phenotypes may be mild or ambiguous, possibly leading to misdiagnoses or missed diagnoses. In this review, the main differential diagnoses of hypertrophic cardiomyopathy (e.g., athlete’s heart, idiopathic left ventricular hypertrophy), arrhythmogenic cardiomyopathy (e.g., adipositas cordis, myocarditis) and dilated cardiomyopathy (e.g., acquired forms of dilated cardiomyopathy, left ventricular noncompaction) are discussed. Moreover, the diagnostic issues in SCD victims affected by phenotype-negative hypertrophic cardiomyopathy and the relationship between myocardial bridging and hypertrophic cardiomyopathy are analyzed. Finally, the applications/limits of virtopsy and post-mortem genetic testing in this field are discussed, with particular attention to the issues related to the assessment of the significance of the genetic variants.     

立井过砂岩富含水层工作面预注浆分析

郑煤集团杨河煤业43采区樊寨副立井施工中需要穿过预计涌水量187 m³/h、厚57 m的砂岩含水层。针对第1回次采用普通水泥工作面预注浆、吸浆量少、升压快、效果差、达不到预期目的等不利情况，在后3回次采用大压力，白银水泥、超细水泥等新材料、单孔上下端正反同时注浆新工艺，采用压注清水、水玻璃，利用水玻璃的黏性，反复冲洗钻孔把细小裂隙中锈蚀颗粒带出，打开注浆通道，同时针对竖向裂隙多、横向裂隙不联系，加密钻孔布置，缩小注浆段高，取得了较好的注浆效果。     

Flow conditioning system for tri-sonic high pressure aerothermal testing

Blowdown testing offers a cost-effective experimental tool to replicate the aerothermal conditions in numerous high speed systems. The wind tunnel must replicate the inlet operating conditions, while the spatial and time dependent inlet flow conditions should be assessed carefully. This paper provides a design methodology and rules that ensure adequate flow conditioning in high inlet pressure wind tunnels suitable for subsonic and supersonic operation with mass-flow limits ranging from 1 kg/s to 25 kg/s, Reynolds numbers from 10³ (1/m) to 4x10⁷ (1/m), and Mach numbers from 0.01 up to 6. The quality of the proposed flow conditioning system was evaluated using stereo PIV measurements combined with hotwire, Pitot probe, and total flow temperature traverses.